Solutions To Frequently Faced Problems Problem Cause Clogged tooth gullet Pitch too low Poor quality of the cut surface Wrong tooth form Wrong cutting parameters Cutting speed too high Insufficient lubrication Poor cutting performance Wrong feed rate per tooth Wrong cutting angles Filling material at the tip of the tooth Poor sharpening Filling material on the sides of the tooth Vibration during cutting Insufficient lubrication Excessive disc side run – out High working parameters Blade breakage during cutting Poor clamping of the piece being cut Unsteady feed rate Wrong pitch Burn marks on the piece being cut Worn saw blade Insufficient lubrication Solution Reduce number of teeth . Contact our technicians Verify cutting parameters on the chart Reduce the number of revolutions Increase pressure and flow rate of the coolant Verify feed rate with charts . Verify cutting angles Verify sharpening quality Verify stability of piece Verify flow rate of coolant Use reduced side run – out sawblades Verify parameters with the charts Verify the quality and strength of clamp Verify feeding system of the cut – off machine Verify parameters against the charts . Blade must be resharpened Increase coolant flow / Check concentration imechelec CAMBO